Skip to main content
Mission Bio Support Center Help Center home page Support Center
  • Submit a request
  1. Mission Bio Support Center
  2. Sequencing
  3. FAQs

What loading concentration should I use?

  • Updated April 10, 2020 17:39

MiSeq V3

20 – 22 pM
HiSeq 2500 8 – 10 pM
HiSeq 3000 250 – 300 pM
HiSeq 4000 250 – 300 pM
NextSeq 500/550 1.8 – 2 pM
NovaSeq 6000 300 – 400 pM
Share this article:

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Related articles

  • What concentration of PhiX should I use?
  • Which sequencing chemistry do you recommend?
  • Which sequencer should I use?
  • Can I reduce the DNA library concentration to < 5 nM?
  • What do I do if my sequencing run is overclustered?

Articles in this section

  • What sequencing coverage is recommended?
  • What do I do if my sequencing run is overclustered?
  • What do I do if my sequencing run is underclustered?
  • What if my pass-filter read is < 85 % after sequencing?
  • How do I quantify my Tapestri library for sequencing?
  • Can I use NextSeq 500/550 to sequence my libraries?
  • Is the Custom Sequencing Primer required?
  • Can I convert BCL files to FASTQ files?
  • What causes a low % of mapped reads to cells?
  • Can I reduce the DNA library concentration to < 5 nM?

See more

Privacy Policy Terms of Use Copyright © Mission Bio. All rights reserved.